Download user manual

Table 8.3 Da& Range Error Codes (continue)
Data Type
Check Ranqo
following ranges.)
Start number
1 to 400
0 to 19
Pointer
Starting bias speed to parameter
speed limit (Not 0)
S p e d change
Positioning
start data
Present value
change
0 to 1,620,000,000
in mm, inch, or
degree
0 to
16,252,928 in PLS
Jog speed
Starting bias speed to parameter
jog speed limit (Not 0)
Start axis
When two axes are to be started at
the same time, both must be set
for interpolation start (00) or for
dual axis start (1 1).
Start axis
The second axis must not be busy
or must be behind the start point
when an interpolation start (00) or
a dual axis start ( 1 1) i s called.
Inching
operation
speed
Remarkr
(Errors occur outride the
Check Point
I
1 to 20,000
'1
I
I
'2
'1
I
I
C
'1 : If the set speed exceeds the parameter speed limit value, positioning is controlled at the
parameter speed limit value.
"2: If the units are mm, inch, or degree and travel per pulse is 'a' (unit/PLS), the address S
range is restricted as given below:
1
(unit) 5 16,252,928(PLS)
a (unit/PLS)
'3: When the travel distance per pulse is set to 1.
,
8-4