Download Manual - Lindos Electronics

Table of Contents 1. Introduction to the DS10 2. Installing the DigiSonic 2.1 Calibrating the Sound Card 2.2 Calibration Method 1 2.3 Calibration Method 2 2.4 Installing Lin4WinXP 2.5 Running a Sequence 3. Stand‐Alone Use (Without Lin4WinXP) 3.1 Oscillator Use 4
5
6
6
7
8
8
10
10
3.1.1 Setting the Output Waveform 10
3.1.2 Setting the Output Frequency 10
3.1.3 Setting the Output Level 10
3.1.4 Channel Selection and Mute 11
3.2 Level Measurement 3.3 Noise Measurement 3.4 Distortion Measurement 3.5 Crosstalk Measurement 3.6 Frequency and Phase Measurements 3.7 PPM (Peak Programme Meter) Use 3.8 Spectrum Analysis 3.8.1 FFT Windowing Options 11
11
12
13
13
13
14
14
3.8.2 FFT Averaging Options 15
3.9 Oscilloscope View 4. Using the DigiSonic with Lin4WinXP 4.1 Remote Connection 4.2 The DigiSonic Toolbar Button 4.3 Swept Distortion Graph Options 5. Sequence Testing 5.1 Downloading and Interpreting Results 5.2 Inter‐working with the MS10 5.3 Inter‐working with the LA100 5.4 Notes on Sequences and Segments 5.5 Segment Details (V1.0) 6. Appendix A ‐ Remote Commands 7. Appendix B – Known Problems and Bugs 16
17
17
17
17
18
18
18
19
19
20
21
22 3