Download USER`S MANUAL

Transcript
7 Key correction
19
Press to enable key correction the light will turn on and the key won't change when adjusting
the pitch slider. Press again to disable key correction the light will turn off.
20
17
18
8 Quartz lock
ON - Will hold the revolution speed at exactly the specified speed.
OFF - Will allow use of the pitch adjust.
16
9 Reverse/Motor off
15
1
14
13
2
12
11
Press this button to switch the reverse and forward playback.
Hold the reverse button more than 0.5sec , the orange light will on and the player
will brake stop; hold the button again to disable the motor off.
10 Headshell
The cartridge has been pre-mounted on the headshell.
When installing a cartridge, refer to the installation instructions supplied by the
manufacturer of that cartridge.
During installation, attach the stylus protector to guard the stylus tip from damage.
3
10
4
START/STOP
11 Pitch slider
Use this to change the speed of the platter when the PITCH button is lit. You can
adjust the speed in a range of +/-8% or +/-12%.
12 Headshell locking nut
5
6
7
8
9
Attach headshell by inserting into the front end of the tone arm, then turn the locking
nut clockwise with the head shell firmly held horizontally.
13 Tonearm
1 Strobe dots
14 Tone arm clamp and rest
Use this rest the tone arm and clamp it in position during transportation.
15 +/-8% / +/-12% switch
2 Voltage selector
230V
115
Check that the voltage selector switch is set to an appropriate voltage before use.
Press this button to switch pitch in +/-8% that green light is on and pitch in +/-12% that
red light is on.
16 Counterweight
230
115V
Use this to balance the tone arm and to adjust the stylus pressure.
17 Extra stylus holder
3 Power dial (POWER)
Place extra headshells here.
ON-Rotate right
OFF-Rotate left
18 45rpm adaptor holder
4 Start/Stop button (START/STOP)
Press this button to start and stop the platter rotation.
5 Platter revolution speed buttons
Place on the attached 45 rpm adaptor here.
Push down the rear side of 45 rpm adaptor to take it.
19 Remote Start / Stop
This jack can be connected with an external switch to perform the Start / Stop
operation.
33 rpm - Press 33
45 rpm - Press 45
78 rpm - Press 33 and 45
20 Output terminal (DIGITAL OUTPUT)
6 Target light
Press the button to the right and a light will pop up directed at the stylus position.
4
Use this output to connect your STR8-80 to a digital device such as a CD-R or
Computer.
5
PART NAMES AND FUNCTIONSPASSEMBLY
TOP PANEL