Download User`s Manual
Transcript
Appendix Troubleshooting Troubleshooting Safety output OFF state while there is no intrusion by an object This may happen due to: 1. Mutual interference This may happen if light from another scanner (OS32C) or other type of photoelectric sensor such as a safety light curtain, is transmitted into the OS32C. In such a case, install the sensor so that its scanning plane does not receive light from the other sensor. When positioning the OS32C downward, the OS32C may be affected by reflection from the floor surface. Effect of reflection may increase depending on the material of the screen. Be sure to check surrounding environment before installing the OS32C. For mounting, see Chapter 4 Installation. Chapter 7 Highly Reflective Wall Metal pole Source of interference Fig. 7-1 2. Incorrect monitoring zone configuration A safety zone may have been configured too close to any objects. Since the maximum measurement error of the OS32C is 100mm, the safety zone must be configured at least 100mm away from any objects. An additional measurement error may need to be added due to reflective backgrounds. Additional Error due to Reflective Background p.123 3. Incorrect zone delay setting The OS32C will turn OFF if the zone set select input pattern does not fit to any of the patterns configured with the configuration tool within the configured zone delay time. Set the zone delay time to adjust to the specified zone set select input pattern within the given zone delay time. Zone Set Switching p.25 4. Bright light/Stroboscopic light Ambient light including high density factory lighting and strobe flash may directly affect the OS32C. An angle of +/-5 degrees must be maintained from the laser scanning plane. Mounting Considerations p.76 118 OS32C User’s Manual