Download Anthos ADAP Software for Zenyth 200

Running Cuvette Applications
12-27
6. When the measurement is complete, remove the cuvette. Samples Read
displays sample IDs and the status of the measurement: OK or Error. The OD
measured is displayed in Actual Value (Figure 12-16).
Actual Value
Displays OD after an
endpoint measurement.
Figure 12-16. Cuvette Reading — endpoint results with Actual Value
7. In Samples to read, select the next sample to read and repeat steps 3 – 6 to
perform the cuvette application again.
Note: The number of samples to read is entered in Sample Count in
the Applications tab.
OR
If desired, in Samples read, select a sample, choose Reread, and repeat steps 4
and 6 to perform the cuvette application on that sample again.
OR
From the File menu, choose End to close Cuvette Reading and save the
measurement results. Plate-ID appears (Figure 12-17).
Figure 12-17. Plate-ID for a cuvette measurement
ADAP Software for Zenyth 200 Operating Manual