Download T-Jet 2 Manual - Equipment Zone

T-Jet2™ User
’
sManual
Since the pretreatment process can take some time to dry, it is recommended that
you pre-treat as much of the production run as possible to avoid delays due to drying
time (Do this only after becoming proficient with the Non-Textile
Primer/Pretreatment).
Setting up an Image for Print
To setup an image for print, you must use a graphic application such as
FastARTIST, Photoshop, or CorelDraw. Anyone of the three applications are
capable of printing to FastRIP, but for this manual we are going to setup the image
using FastARTIST. The steps in the other graphic applications will be very similar;
pl
easecons
ul
ty
ourappl
i
cat
i
onsowner
’
smanuali
fneeded.
1. Setup the printing area in which you will be printing on. To
do this you will need a measuring tape and will need to
measure the width and height of the Non-Textile item. Now
in FastARTIST select File > FastRIP Setup.
2. From the Setup window, select
Page Setup Tab. In the Page Setup
Tab select Custom under the page
option. Now enter the height/width
of the Non-textile item you
measured. When you are done
entering in the values click OK to
return to back to the workspace.
94