Download ANALOG SEEKrets

Transcript
356
ANALOG SEEKrets
*EX 17.10.1: The digital guys need a hand. They have a 200 ps edge-speed clock to
transmit to three gates spaced out in different areas of a PCB. The layout is roughly as
shown below.
FIGURE 17.10L:
10 cm
source
Gate 1
5 cm
Gate 2
5 cm
Gate 3
They want to wire this circuit up to
get good pulse edges and to minimise
skew. One suggestion is to run the
feed from the source directly to gate 1,
then follow on down to gates 2 and 3,
with a parallel termination at gate 3.
Another suggestion is to seriesterminate at the source and feed to
gate 2, with stubs going off to gates 1
and 3 of equal length.
What is your advice?
When using coaxial interconnects between different PCBs it is possible to play games
with the series and parallel termination values to optimise the pulse response. This
tuning is not restricted to just changing the resistor values up and down. It is possible to
add small capacitors and/or inductors into the circuit to minimise overshoot, peak up an
undershoot, and generally fine-tune the pulse response and/or frequency response.
17.11 Filters
The subject of filters is more than enough to completely fill a large book. If you have to
do a lot of work with filters having more than three poles, you definitely need to get one
or more books on the subject and/or some filter design software. However, the first thing
you need to establish is your need for more information on the subject, or indeed your
lack of need for more information than is contained here.
*EX 17.11.1: What is the purpose of an electrical/electronic filter?
The whole idea of filtering has to do with the terms signal and noise. The signal is what
you want; the noise could be said to be anything else that you don’t want. In a telephone
system where individual telephone messages occupy their own band of frequencies, it is
clear that you want to separate out one particular telephone conversation from the
“noise” of all the other conversations.
An ideal filter would therefore pass the signal without attenuating or distorting it at
all; this filter would also give sufficient attenuation to the noise to make it imperceptible.
Now this is a tough spec and in practice it is impossible to meet. A filter will distort the
signal at least a small amount, and noise will get through to at least a small extent as
well. Obviously the more components you use, and the more design time you expend,
the better the filter can perform to the original spec. It is the same old fundamental of
design; just how much is somebody prepared to pay to get a given performance?