Download ANALOG SEEKrets
Transcript
180 ANALOG SEEKrets The ADC is sampling at perhaps 100× the output data rate in order to get enhanced resolution. A group of sequential data points is digitally filtered to produce a single data point with enhanced resolution. A simple way of doing the filtering is to just sum the data points together. Notice that this scheme averages the dither signal to zero, but it also puts a low-pass filter on the acquired data as well. FIGURE 11.4C: The exact equation for the bandwidth of a block accumulated scheme, also known as a boxcar average, is quite unpleasant (see appendix). However, the approximation, shown dotted, is simple and accurate: B ≈ 0.443 × FOUT If a 100 MS/s data stream is averaged in blocks of 10 then the output data rate, FOUT , is 10 MS/s and the bandwidth is reduced to 4.43 MHz. This formula does not work for a block size of 1, ie no averaging, as the bandwidth would not be limited by the ‘filter’. The formula and graph rely on the actual system bandwidth being much greater than the predicted filter bandwidth. If the system bandwidth is more than 10× the filter bandwidth, the error caused by neglecting the system bandwidth will be less than 0.5%. This ADC enhancement scheme looks too good to be true, and it is. You will not be able to take an 8-bit converter and enhance its ENOB from say 7 bits to 9 bits using this scheme. The reason is that this dithering scheme is interpolating between the LSB thresholds. As such, it does not correct the inherent DNL and INL of the converter. Therefore the result is not very accurate and less ENOB enhancement is achieved than might be expected. For use on integrating ADCs, where the DNL is very always very good, the 1 LSB dithering scheme is excellent. However, it is not as useful for flash converters, where the DNL can easily be as bad as ±0.9 LSB. In this case the DNL of the converter also has to be decreased if a good increase in ENOB is to be achieved.
Related documents
赤 黒 青 白 A B C D E
会議録(PDFファイル 410KB)
Merlin Plus R2 System Manual
Manual For Experiment
User Manual Engine Compartment Measurement
Corpora and LSP Translation Natalie Kübler1 0. Introduction This
Available in
Practical Notes
Automation of Testing of Polymer HVDC Cables using
Doppler Radar for Biomedical Measurements - 2004
A6 発振回路(3ページから5ページまで)
"user manual"