Download warning - HE Services

INSTRUMENTS AND CONTROLS
2.
Quick deceleration warning light
This warning light (2) informs the operator that the quick deceleration function has been activated.
Function activated: warning light on.
Function deactivated: warning light off
When the quick deceleration switch is pressed, the corresponding
warning light comes on. When the switch is pressed again, the
light goes out.
NOTE
q When the quick deceleration warning light comes on, the engine rpm remain at the minimum value even if the hand accelerator is operated.
INDICATORS AND METERS
3.
ENGINE COOLANT TEMPERATURE INDICATOR
This indicator (3) shows the engine coolant temperature. When
the engine is running normally, the green area (A) of the indicator
should be lit.
If the red area (B) of the indicator lights up during operation, let
the engine idle and wait for the temperature to decrease until the
green area (A) lights up again. After starting the engine, keep
warming it up until the coolant temperature increases and the
green area of the indicator lights up instead of the white area (C).
NOTE
q When segment D lights up, also the engine coolant temperature
warning light (F) starts blinking.
q
4.
When segment E lights up, also the engine coolant temperature
warning light (F) starts blinking. The acoustic alarm sounds at
the same time.
FUEL GAUGE
This indicator (4) shows the fuel level in the tank. When the engine is running normally, the green area (A) of the indicator should
be lit. If the red area (B) starts blinking while the engine is running,
this means that there are still 30 litres of fuel in the tank, therefore
it is necessary to check and refuel. The correct level may not be
indicated for a short lapse of time soon after the ignition switch
has been turned to position ON, but this does not mean that there
is an anomaly.
NOTE
q When the red area (B) of the fuel gauge lights up, also the fuel
level warning light (C) starts blinking.
77