Download IM CA150E - Yokogawa

Transcript
Chapter 3.4 Opereting Environment
Internal Wiring
Distribution
Board
Entrance
Cable
CAT. IV
CAT. III CAT. II
T
CAT. I
3
Outlet
Equipment
Pollution Degree
Pollution Degree applies to the degree of adhesion of a solid, liquid, or gas
which deteriorates withstand voltage or surface resistivity.
The pollution degree of the CA150 in the operating environment is 2. Pollution
Degree 2 applies to normal indoor atmospheres. Normally, only non-conductive
pollution is emitted. However, a temporary electrical conduction may occur
depending on the concentration.
Note
• For accurate source and measurement, operate the CA150 in the 23 ± 5C temperature range and 55 ± 10% RH.
• Condensation may occur if the CA150 is moved to another place where the
ambient temperature and humidity are higher, or if the temperature changes
rapidly. If this happens, let the CA150 adjust to the new environment for at
least two hours before using it.
Strage Location
• We recommend you store the CA150 in an environment with a temperature
between 0 and 50C and a relative humidity between 5 to 85% RH.
• When storing the CA150, avoid a location that is:
• exposed to direct sunlight,
• 60C or higher,
• 90% RH or higher,
• close to a heat source,
• exposed to servere vibrations,
• exposed to corrosive or explosive gas,
• exposed to excessive amount of soot, dust, salt, and iron, or
• exposed to water, oil, or chemicals.
IM CA150E
3-11
Before Starting Source or Measurement
Fixed Equipment,
etc.