Download IOM
Transcript
Additional Information for Alicat CSA and ATEX Approved Devices See the following page for Special Conditions regarding the use of these units! II 3 G EEx nA IIC T4 Class I, Div. 2 Group A, B, C and D T4 24 Vdc, 0.800A max Class I, Zone 2 AEx nA IIC T4 WARNINGS: EXPLOSION HAZARD – DO NOT DISCONNECT WHILE CIRCUIT IS LIVE UNLESS AREA IS KNOWN TO BE NON-HAZARDOUS. EXPLOSION HAZARD – SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY FOR CLASS I, DIVISION 2. All Alicat CSA / ATEX approved devices are equipped with a locking 6 pin industrial connector. The power and signal connections are shown below. 6 5 1 1 5 6 4 2 3 3 Female Connector: Device Min. Clearance w/ Cable Bend Function Industrial Connector Overall Clearance Power In ( + ) RS-232TX RS-232RX Remote Tare Meters (Ground to Tare) 2.537 1.817 1.602 Analog Set-Point Input (Controllers) Description 5 Ground (common Description for Date power, Rev. No. Date communications and signals) 6 Signal Out (Voltage or Current as ordered) Clearance Requirements for Industrial Connector Minimum Removal Clearance Pin 1 2 3 4 4 Male Connector: Cable 2 69