Download User Manual - Solar Technology

Transcript
Message to Current Quick Picks. If the desired Message is not in
the Message Library follow Message Creation & Editing
procedures to add the desired Message to the Message Library.
[Note: up to six (6) messages may be added to theCurrent Quick
Picks message list.]
-
To remove a Message from Current Quick Picks touch the desired
Message in Current Quick Picks and then touch Left Arrow
Button ( <= ).
-
When finished touch the Finished button and then touch the Log
Out button.
-
View System Status (Displays Current Time, Date, Photocell Reading,
Battery Voltage, Temperature, MAC Address, IP Address, Up-Time,
Current Run-Time, Lifetime Run-Time, Serial Modem Type, Signal Strength
and Signal Quality.
-
Blank the Sign Panel (Blanks the Sign Panel) – follow on-screen
instructions provided.
-
Test Display Modules (Tests LED Display Modules & Sign Panel
operation) – use arrow buttons provided to turn on and test specific LED
Display Modules on the Sign Panel – numerical address of current LED
Display Module under test is provided to aid in diagnostics – for
assistance contact Customer Service.
-
Help (Basic operational instructions)
-
Solar Panel Orientation (Controls actuator equipped solar arrays) –
follow on-screen instructions provided.
-
Main Menu (Returns to Main Menu)
-
Log Out (Logs Out and returns to SolarTech® Splash Screen)
o Supervisor Menu - access requires log-in with a Supervisor or Administrator
Password (if Password Security is enabled – see Enabling Password Security)
-
Manage Quick Pick Users (Add & Remove Quick Picks Users)
-
Manage General Users (Add & Remove Users)
-
Set Date & Time (Setting Date, Time, and Time Zone – for proper DST
operation)
-
Set Photocell Limits (Used to adjust Photocell Light Level Parameters) –
Note: factory default settings are 1500 and 3750 – it is not recommended
- 4-11 -