Download "user manual"

8. Click the IBMDirector Service Access Point edit icon and select Add Credentials:
password. Do the following:
– In the Search Key field, enter IBMDirectorCLI .
– In the User Name field, enter the ID that has administrative access to IBM Director on
the IBM Director Management Server.
– In the Passphrase field, enter the password for the entered user ID.
– Leave the Enable Password and Key Fingerprint fields blank.
9. Click Save.
10.Click Edit, and then Add Access Point.
–
–
–
–
–
In the Name field, enter: SSH.
In the Type field, select ipv4 / SSH.
Select Authentication.
Ensure that Host is selected.
Set the locale to en_US.
11.Click Save.
12.Click the SSH Service Access Point edit icon and select Add Credentials: RSA.
– In the Search Key field, enter executecommand.
– In the User Name field, enter the ID that has administrative access to IBM Director on
the IBM Director Management Server.
13.Click Save.
14.Click that icon to the right of the credential and set it to default.
15.Click SSH Service Access Point on the Workflow tab, then click Logical Device
Operation. Select -all workflows. Attach the following workflows:
–
–
–
–
Default_Device_Execute_Command
SCP_Copy_File
SSH_Ping_IP_Address.
SSH_RSA_Execute_Command
16.Go to the Credentials tab, and assign the SSH Service Access Point to the Device
Operations execute-command and file-transfer.
Spare Blade
To configure the spare Blade, do the following:
1. From the navigation bar, expand Servers, then Spare Pool, and click the spare server
resource, BLADEHS20_01.
2. Go to the Variable tab and add the variable as shown in Table 12-2.
Table 12-2 Adding a variable into the spare pool
Key
Component
Value
UUID
Entire System
422EA9DADF1DB211A72B5C
DA030C8B48
Chapter 12. How to fix hardware constraints using TPM and IBM Director
303