Download User manual Expert
Transcript
2 Setup and Operation The Gendex expert DC Master Control Touch Panel contains a microprocessor. The microprocessor enables and controls exposure values for film and digital imaging receptors. This chapter presents the following sections: • Master Control Function • Setup • Operation • Customize Master Control Settings • Default Exposure Values (Anatomical Exposure Times) Tables 2.1 Master control function The Gendex expert DC Master Control Touch Panel provides the following function: • Preset anatomical time settings • Single button selection for patient type • Single button selection for film or digital imaging receptor • Customization capability Preset anatomical time settings allow the user to choose technique values corresponding to imaging type, anatomical area, or patient type selections. The anatomical time settings are based on the following criteria: • Media type exposure time – Film speed (SP) D, E, F or digital imaging (PhotoStimulable Phosphor System (PSP) – digital (D)1; Charged Coupled Device (CCD) or Complementary Metal Oxide Semiconductor (CMOS) Systems – D2) • Intraoral anatomy area – Incisor, Bicuspid, Bitewing, Lower Molar, Upper Molar • Patient type – adult or child The values (exposure times with associated intraoral anatomy areas) are preset at the Gendex factory. The factory default settings are indicated (an LED light appears next to each default selection) on the master control touch panel when the touch panel is initially turned on for normal operation. The default settings or standard factory configuration consists of the following: standard 8" (20cm) focal length cone, bitewing anatomical section, and film media for an adult patient. For all other exposure times, the Gendex Factory Default Time Tables are provided in this chapter. 7 User Manual PEXPERTUM May 2007