Download User Manual

Operation
ER Code
05
Alarm
Compressor run time
Floating
contact
-
Causes
•
•
•
•
06
Make-up time
-
Set value exceeded.
Severe water loss in
the system.
Air lines leaking.
Solenoid valve in the
overflow line does not
close.
•
•
07
Make-up cycles
-
08
Pressure measurement
YES
•
•
•
•
Set value exceeded.
Water loss in the
system.
• Make-up line not
connected.
• Make-up rate
insufficient.
• Make-up hysteresis
too low.
Set value exceeded.
•
•
Controller receives
incorrect signal.
•
•
•
•
•
•
•
09
10
Level sensor
Maximum pressure
YES
-
Controller receives
incorrect signal.
•
•
•
11
Make-up quantity
-
Set value exceeded.
Overflow line
disabled.
Dirt trap clogged.
"With water meter" must
be activated in the
Customer menu.
• Set value exceeded.
• Severe water loss in
the system.
•
•
•
•
•
•
•
•
Remedy
Alarm reset
Check set value in the
Customer or Service menu.
Check the water loss and
correct, if necessary.
Seal any leak in the air
system.
Check functioning of the
"PV1" solenoid valve.
Check set value in the
Customer or Service menu.
Check water level.
Connect make-up line
-
Check set value in the
Customer or Service menu.
Seal any leak in the system.
Connect the plug.
Check functioning of the
pressure sensor.
Check the cable for damage.
Check the pressure
transducer.
Check functioning of the oil
pick-up sensor.
Check the cable for damage.
Connect the plug.
Check set value in the
Customer or Service menu.
Check functioning of the
overflow line.
Clean the dirt trap.
Check set value in the
Customer or Service menu.
Check water loss in the
system and repair, if
necessary.
Reflexomat with Basic controller — 13.05.2014
"Quit"
"Quit"
"Quit"
"Quit"
"Quit"
"Quit"
English — 51