Download dBTrait 4.7 User Manual

Transcript
DBTRAIT32 SOFTWARE PACKAGE USER MANUAL
7.2.
Cumulative distribution
The cumulative distribution plot is used to display statistical indices (or percentiles) graphically. The percentiles may
be calculated with a narrow integration step (0.1 dB), which allows particularly accurate study of the level
distribution. The cumulative distribution is displayed regardless of the existing noise sources (overall result).
Use the command Display / Cumulative distribution to plot the statistical distribution. The following dialog box
appears on screen:
Measurement
channel to take the
noise data from
Time portion to
consider
Define the class width
of the distribution plot
The width of each class is defined in dB. This value can vary from 0.1 dB to 20 dB in 0.1dB steps.
Below is a typical cumulative distribution plot (statistical indices in classes of constant width as a function of level in
dB):
In the above example, the statistical index L64.5 = 48 dB(A). It means that the noise levels in the datafile are
equal to or greater than 48 dB(A) during 64.5% of the time.
Similarly, the statistical index Lmin, corresponding to the minimum short Leq value of the considered time portion is
equal to 40 dB(A) in our example. It corresponds to the index L100, the noise level that is exceeded during 100% of
the time.
The statistical index Lmax, corresponding to the maximum short Leq value of the considered time portion is equal to
72 dB(A) in our example. It corresponds to the index L0, the noise level that is exceeded during 0% of the time.
CHAPTER 7 - STATISTICAL DISTRIBUTION PLOTS
PAGE 60