Download TracMap Flight

Chapter 4
Command reference
This section describes the commands available on the TracMap Flight head unit. The
commands are listed in alphabetical order. Navigate the menu by using the rocker
pad to highlight items, then press ENT to select the item.
Only three commands (and Next page & Prev page) will be displayed on the menu
at a time. You can view the complete list of commands by activating the Next page
and Prev page commands as necessary.
The top three menu items can be activated using remote switches (cyclic switches,
buttons) if the switches have been wired as per the instructions in Chapter 2.
4.1 Baseline
The Baseline function can be used for simple guidance when flying in parallel lines.
It can be used with or without a block outline.
To use the Baseline function, first ensure that you have a block selected, as this
function will not create a new block. If you want to fly without a block outline,
create a new block but don’t add any points to the boundary.
Select Baseline then fly the first swath. Flight lines will be oriented so that the first
line passes through the start and end points of the first swath recorded.
23