Download User Manual

InteriCAD T5 User Manual
2.
Switch back to the InteriCAD VR interface. From Animation menu
select Select Path command.
3.
The default option Set Path For Camera in the pop-up dialogue box is
ok. Single click the Select path button, and then the system will switch
to Modeling automatically.
4.
Under the prompt of Select camera path select the polyline that has
been drawn just now.
5.
The height of polyline drawn directly in the plane drawing should be 0.
But the height of the camera path should not be 0. It is recommended
that the starting height of the camera should be around 1500 to
simulate the height of a people‟s eyes. So the default setting is ok.
6.
Input the total number of frames of the animation.
7.
Single click the OK button.
Basic Operations of Setting the Path of Camera and Target Path
1． Switch to Modeling and use polyline command to draw one polyline as the
path of the camera and the other polyline as the path of the camera target
point.
398