Download User Manual

/purge nofile
File "!" not found. No purge done. (CIWARN 383)
/setvar robmsgfence 1
{suppress warnings}
/purge nofile
/build nofile;temporary
Unknown keyword for BUILD command. (CIERR 299)
/setvar robmsgfence 2
{suppress errors and warnings}
/build nofile;temporary
/setvar robmsgfence 0
{display errors and warnings}
/build nofile;temporary
Unknown keyword for BUILD command. (CIERR 299)
/purge nofile
File "!" not found. No purge done. (CIWARN 383)
UDC Security
Some users have altered the security of Command.Pub.Sys to be
(X,L:ANY; R,A,W:CR). If you do this, the Set Udc On command will
not be able to search Command.Pub.Sys. Use Set Udc with file names
instead.
UDCs with Parameter Substitution
Here are two UDCs with parameters, :Compare and :Seg.
/set udc compudc.catalog.robelle
/:help compare
USER DEFINED COMMAND:
COMPARE filea, fileb, outfile="$STDLIST", info=""
comment
comment Compare two files using the Compare program.
comment
file filea=!filea
file fileb=!fileb
file outfile=!outfile
run compare.pub.robelle;info="!info"
reset filea
reset fileb
reset outfile
****
You invoke the Compare UDC by entering:
/:compare *,origfile
{* means current workfile}
In Qedit, an * as a parameter to a User Command substitutes the name
of your current workfile or the last one you Shut. As well, $ as a
parameter substitutes the name of the last external file name mentioned
(Verify Lastfile).
The Seg UDC gives you the ability to execute a file of :Segmenter
commands without typing them interactively and without streaming a
batch job.
336 • Qedit Commands
Qedit 6.0 for HP e3000 User Manual