Download TEQ-C7489

Transcript
DISPLAYING THE PICTURE
1. Activate your signal source. Turn on the signal source,
and make it send the signal to the projector.
2. Use the VOLUME + / VOLUME - buttons to adjust the
volume. To silence the projector, press the MUTE button
on the remote control.
3. Press the INPUT button on the projector. Each time
you press the button, the projector will switch its input
port. You can also use the remote control to select an
input signal. Press the VIDEO button to select an input
signal from the HDMI, COMPONENT (Y, Cb/Pb, Cr/
Pr), S-VIDEO or VIDEO port, or the COMPUTER button
to select an input signal from the COMPUTER IN1,
COMPUTER IN2, LAN, USB TYPE A or USB TYPE B
port.
4. Press the ASPECT button on the remote control. Each
time you press the button, the projector will switch the
mode for aspect ratio.
5. Use the zoom ring to adjust the screen size.
6. Use the focus ring to focus the picture.
CAUTION
n
If you wish to have a blank screen while the projector’s lamp is on, use one of methods below:
-
Use the supplied lens cover.
-
Use the BLANK function.
n
Taking any other action may cause the damage on the projector.
NOTE
n
The ASPECT button will not work without the proper signal.
13