Download IAI 2 Impedance Analysis Interface USER MANUAL

Impedance analysis interface user manual
4 Connecting to the DUT
4.1
Kelvin leads
The IAI2 is supplied with a pair of Kelvin leads for low
frequency use (<5MHz) which make simple connections to
a discrete component.
The red lead should be connected to the BNC connectors
marked SIGNAL+ and SENSE+ on the front of the IAI2;
the black lead should be connected to the BNC connectors
marked SIGNAL- and SENSE-.
The Kelvin clips can then be clipped onto the body of the
component, as close as possible to the component.
For accurate measurements it is essential that the
component leads are clean. For repeatability of
measurements, it is important to connect the Kelvin clips
in the same physical arrangement when testing different
components.
signal+
IAI2
sense+
DUT
sensesignal-
4-1