Download 112k - Fairchild Engineering Ltd

Transcript
Installation
PCL-720
Slide the system unit's cover away from the rear and to the front. When the
cover will go no further, tilt it up, remove it from the base, and set it aside.
The PCL-720 is configured at the factory for the IBM PC, PC/XT, PC/AT and ah
IBM PC compatibles. If you need further changes to the configuration please
refer to Chapter 2. Installation.
Use a screw driver to remove the screw that secures the expansion slot cover.
Save the screw for installation of the interface card.
The two rear connectors should be pressed through the rear panel first, then
press the card carefully into the main board expansion slot.
Secure the PCL-720 with the 3/16" mounting screw, then attach and appropriate
cable to the connector.
Slide the system unit's cover back on. Align the system unit tabs with the
cover holes and reinstall the cover mounting screws.