1
Download View the user manual
Transcript
TYPICAL INSTALLATION GET TO KNOW YOUR WATER HEATER REPLACEMENT PARTS Replacement parts may be ordered through authorized servicers or distributors. When ordering parts, provide complete model and serial numbers (see rating plate), quantity and name of part desired (as listed in Figure 1). Standard hardware items may be purchased locally. COLD WATER INLET PIPE TRIM PLATE (OUTSIDE) TRIM PLATE (INSIDE) INLET VALVE VACUUM RELIEF VALVE UNION HOT WATER OUTLET PIPE THERMAL EXPANSION TANK INLET DIP TUBE ANODE INSTALL THERMAL EXPANSION TANK IF WATER HEATER IS INSTALLED IN A CLOSED SYSTEM. INSTALL PER LOCAL CODES. PILOT TUBE TEMPERATURE AND PRESSURE RELIEF VALVE THERMOPILE CONNECTOR PILOT / THERMOPILE ASSEMBLY SCREW WHITE WIRE FLUE BAFFLE IGNITER WIRE RETAINER CLIP MANIFOLD DOOR DISCHARGE PIPE (DO NOT CAP OR PLUG) MANIFOLD COMPONENT BLOCK GAS SUPPLY LINE GAS CONTROL VALVE/ THERMOSTAT MAIN MANUAL GAS SHUTOFF VALVE DRAIN VALVE List of status codes are shown at top of gas control valve/thermostat. GROUND-JOINT UNION SEDIMENT TRAP (DIRT LEG) METAL DRAIN PAN 6” MAXIMUM AIR GAP FLOOR DRAIN OUTER DOOR ALL PIPING MATERIALS TO BE SUPPLIED BY CUSTOMER. FIGURE 1 7 BURNER AND OTHER FITTINGS NOT SHOW FOR CLARITY.
