Download USER MANUAL - Northern Tool + Equipment

Transcript
The diesel engine can not start
CAUTION
Replace the AVR.
AVR is damaged
Charge it or replace it with a new one.
The battery has no electricity.
Adjust it according to the requirements.
Start the enging according to the start
procedures included in this book.
The speed and force to pull the recoil starter are
not enough.
The rated speed can not attached.
Clean the nozzle
The nozzle has dirty.
Adjust the socket.
The specified oil level should be between
the upper level and lower lever
Check the engine oil level.
The contact of the socket is not good.
Set the lever to START position
The governor lever is not at START position.
Replace the carbon brush.
Remove the nozzle and repair it at test
table
Fuel injection pump and nozzle do not delivery
the
fuel or delivery insufficient fuel.
The carbon brush already worn.
Turn it START position
Fuel cock is not at START position
Turn the main switch to ON position.
Refill the fuel oil
Fuel oil is not sufficient
Main switch not be turned on.
Remedy
Fault Cause
10. TROUBLESHOOTING AND REMEDY
The generating
set can not
generate