Download User Manual

Transcript
Technical description
Stealth Telecom
and associated components form a 5VDC stabilizer.
The microcontroller DD1 consists of EEPROM, RAM,
three timers, 8-channel ADC, two 8-bit and one 7-bit I/O
ports and is clocked at 8 MHz rate.
JU logic sequence
Note: This is programmable interfacing function to
support different radiosets. Below’s 9407.20 sequence
is written to support Codan NGT series transceivers.
1.
2.
3.
4.
5.
6.
7.
When tuning is initiated by the transceiver, the Tune
line goes LOW. Transistor Q7 conducts and sets
the pin 10 of the microcontroller at LOW.
In response, the microcontroller immediately sets
HIGH on pins 9 and 1 switching on Q6 to continue to
hold Tune line LOW.
At the same time Q8 is also switched on and sets
Ind line to LOW.
Microcontroller verifies above conditions and sends
command
TUNE
START
to
Main
Unit
microcontroller trough differential RS-485 bus
consisting DD3 and associated components.
Main unit controller executes its own tuning
sequence.
When tuning sequence is completed, the MU
microcontroller informs the JU microcontroller about
results through the RS-485 bus.
Upon the completing the tuning cycle, the JU
microcontroller trough Q6 and Q8 informs
transceiver with one of two results:
TUNE PASS - If line Ind goes HIGH advancing
by 60 ms the line Tune goes
HIGH.
TUNE FAIL - If line Tune goes HIGH advancing
by 100ms line Ind goes HIGH.
8.
9.
If scan mode is selected by the operator or
automatically by the transceiver, the line Scan goes
LOW and trough transistor Q4 applies LOW to pin
12.
The JU microcontroller forms command SCAN and
informs the MU microcontroller through RS-485 bus.
Note: In the Scan mode, the NGT transceivers first tune
antenna to a frequency calculated in accordance with their own
7-10
ST940B Automatic Tuning Loop Antenna