Download User Manual
Transcript
Technical description Stealth Telecom and associated components form a 5VDC stabilizer. The microcontroller DD1 consists of EEPROM, RAM, three timers, 8-channel ADC, two 8-bit and one 7-bit I/O ports and is clocked at 8 MHz rate. JU logic sequence Note: This is programmable interfacing function to support different radiosets. Below’s 9407.20 sequence is written to support Codan NGT series transceivers. 1. 2. 3. 4. 5. 6. 7. When tuning is initiated by the transceiver, the Tune line goes LOW. Transistor Q7 conducts and sets the pin 10 of the microcontroller at LOW. In response, the microcontroller immediately sets HIGH on pins 9 and 1 switching on Q6 to continue to hold Tune line LOW. At the same time Q8 is also switched on and sets Ind line to LOW. Microcontroller verifies above conditions and sends command TUNE START to Main Unit microcontroller trough differential RS-485 bus consisting DD3 and associated components. Main unit controller executes its own tuning sequence. When tuning sequence is completed, the MU microcontroller informs the JU microcontroller about results through the RS-485 bus. Upon the completing the tuning cycle, the JU microcontroller trough Q6 and Q8 informs transceiver with one of two results: TUNE PASS - If line Ind goes HIGH advancing by 60 ms the line Tune goes HIGH. TUNE FAIL - If line Tune goes HIGH advancing by 100ms line Ind goes HIGH. 8. 9. If scan mode is selected by the operator or automatically by the transceiver, the line Scan goes LOW and trough transistor Q4 applies LOW to pin 12. The JU microcontroller forms command SCAN and informs the MU microcontroller through RS-485 bus. Note: In the Scan mode, the NGT transceivers first tune antenna to a frequency calculated in accordance with their own 7-10 ST940B Automatic Tuning Loop Antenna