Download User Manual

8. Appendix
Cable Connection
Communication Protocol
Baud rate........................................... 19200 bps
Data length........................................ 8 bits
Parity................................................. No parity
Stop bit............................................. One bit
X on/off............................................. None
Communications procedure.............. Full duplex
NOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs.
PC Control Connector (D-SUB 9P)
To TxD of PC
To RxD of PC
To GND of PC
1
2
6
3
7
4
8
5
9
To RTS of PC
To CTS of PC
NOTE 1: Pins 1, 4, 6 and 9 are not used.
NOTE 2: Jumper “Request to Send” and “Clear to Send” together on both ends of the cable to simplify cable connection.
NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.
97