Download Motion Control System and Operator Interface (VC1) User Manual

Transcript
User Manual, Revision 1.9
GL n
Command Reference, Loop Commands
Go to line in sequence
Range : 1 to no of lines in current sequence
This command allows looping to a specified line number within a sequence. Note that it can only be
executed from within a sequence.
Example:
A sequence might consist of the following:
CO3/MR5000
SO4/W T500/II5-/XT
GL1
This will continue looping to line 1 until input line 5 is negative, when the XT command will escape
from the sequence.
Copyright © 2006 Pan Controls Limited
Page 63