Download "user manual"

2
Getting Started with the TDS1000 and TDS2000 Series Oscilloscopes
You use Pulse Width triggering to trigger on aberrant
pulses.
Menu
Option
Description
Pulse
You use this menu to trigger the
oscilloscope on pulses. The trigger
conditions are provided by the Source,
When, and Set Pulse Width options.
Source
You use this menu option to select an
input source for a trigger signal. You
can select input sources CH1, CH2,
Ext, and Ext/5. You can also select
CH3 and CH4 as input sources for the
TDS2014 and TDS2024 oscilloscopes.
When
You use this menu to compare the
pulse width of the input signal with the
condition defined by the Set Pulse
Width time selection. These
comparisons are: equal to, not equal
to, greater than, and less than.
TDS1000 and TDS2000 Series Oscilloscopes – Operator Training Kit
2-53