Download User`s Manual - Particulate Systems

2. Select the vial position number to which acid, base, or other solution is to be set
and select the type of solution. Then enter the molar concentration for each
solution. If a vial is not going to be used, deselect the vial position number.
3. Select the type of vial to be used: 50mL or Beaker.
4. When finished, click [OK] to accept your changes and close the dialog.
Calibration of pH Electrode
Calibrate the pH electrode before starting measurement. Calibration is not required
for each measurement, but it should be done once a day, for example, before the first
titration.
Filling the Titration Solution
When the instrument is used for the first time, or when the titration solution is
exchanged for another solution, fill the solution according to the procedures
described below.
1. Pour the titration solution into the glass vial or plastic vial and put the cap on. Use
the glass vial if the titration solution will be used continuously for more than one
day. You can use plastic vials if using the titration solution for a shorter time.
176