Download Manual

PLGr – Communication to PLGR
GPS*
o PC – Communication to PC*
o Reticule – Change reticule from +
(cross) to (rectangle)
o CAL – Compass calibration
▪
CALc – compass calibration
(CI model only)
▪
Corr – accuracy correction of
active measurement parameters
▪
Display and firmware version
check
*not shown in the menu if currently selected
o
Compass calibration
Full calibration process consists of three procedures,
which shall be conducted in the following sequence:
1.
Elevation correction
2.
Hard calibration
3.
Soft Calibration
However all three procedures shall be done only at
initial installation and integration of the device, or if
some large hardware elements permanently attached
to the device were changed. For example bracket
18