Download Technical Information Manual

Document type:
User's Manual (MUT)
5.11.
Title:
Mod. C111C Ethernet CAMAC Crate Controller
Revision date:
03/12/2008
Revision:
8
Diagnostics page
Fig. 5.9: Diagnostics readout
This page shows current voltage readouts, divided into crate power supplies and local
(digital-only) power supplies.
Note that C111C requires the following voltages to be present in order to work properly:
-24V, -6V, +6V, -24V.
On the bottom of the page, results of the Crate Scan (performed only at power-up if the
CSCAN flag is enabled, see Startup Options section) are shown in textual form.
Remember that if Crate Scan is problematic (depending on which cards are inserted into
the crate) it can be disabled either by serial or control socket.
5.12.
SNTP client
Firmware Rev.2.10 and newer feature the SNTP client. As the system is started, the shell
script /app/start is executed; the firmware contains the command line:
sh /data/custom_start
Normally the shell script custom_start is not present, therefore the command execution is
neglected.
The User can add the fore mentioned shell script in order to execute additional
commands to be performed at system boot, for example to update the system clok via
SNTP server;
For example, the shell script custom_start can be created by typing at prompt:
NPO:
00108/04:C111C.MUTx/08
Filename:
C111C_REV8.DOC
Number of pages:
44
Page:
23