Download DAQSTATION CX1000/CX2000 Communication Interface

7.3 Output Format of BINARY Data
Event Data
• The MI command is used to output the FIFO data.
• The ID number of the output format is “12.” See “Identifier” on page 7-3.
Header
Block 1
...
Block n
BINARY data
(The BINARY data section
on the “Conceptual diagram”
on page 7-2.)
Header
Same as the “Header” for the display data.
Block
2 bytes
Measured data
...
...
Computed data
...
...
Control data
...
...
4 bytes
Special Data Values
The measured/computed/control data take on the following values under special
conditions.
Special Data Value Type
Measured/Control Data
Computed Data
+ Over
– Over
Skip
Error
Undefined
7FFFH
8001H
8002H
8004H
8005H
7FFF7FFFH
80018001H
80028002H
80048004H
80058005H
Note
The measured/computed/control data is output according to the byte order specified with the BO
command.
Manual Sampled Data
• The ME or MO command is used to output the data.
• The ID number of the output format is “4.” See “Identifier” on page 7-3.
• For a description of the data format, see the user’s manual IM 04L31A01-01E or IM
04L31A01-03E.
Report Data (Hourly, Daily, Weekly, and Monthly)
• The ME or MO command is used to output the data.
• The ID number of the output format is “5” for the hourly data, “6” for the daily data, “7”
for the weekly data, and “8” for the monthly data. See “Identifier” on page 7-3.
• For a description of the data format, see the user’s manual IM 04L31A01-01E or IM
04L31A01-03E.
7-30
IM 04L31A01-17E