Download TAKEDO

3) Check the following parameters:
Parameter
Description
Unit
SMS setting
S6.1.2
Language
Italian
S6.2.2
Application
SMSLift Sync
Value to be set
Select according to
country of
SMSLift Sync
Value
Value
4) Enter data in the following parameters:
Parameter
Description
Unit
V
SMS setting
Value to be set
400
Hz
8.00
Motor rating plate data
Motor rating plate data
60
Motor rating plate data
I Inverter
Motor rating plate data
P2.1.2
Motor Nominal Voltage
P2.1.3
Motor Nominal Frequency
P2.1.4
Motor Nominal Speed
RPM
P2.1.5
Motor Nominal Current
A
P2.1.6
P2.1.7.1
P2.1.7.2
P2.1.7.3
P2.1.7.4
P2.1.7.5
Motor Cos Phi
Lift Rated Speed
Pulley Diameter
Gear Ratio
Ropes Ratio
Update Data
0.90
1.00
320
1.01
1:1
No
Motor rating plate data
LIFT data
LIFT data
LIFT data
LIFT data
P2.1.12
Encoder Type
Incremental
P2.1.13
Encoder Direction
Not inverted
m/sec
mm
Yes
Encoder Type:
Incremental or EnDat
Not inverted
if motor
is going up
Inverted
if motor
P2.1.14
Calculated Poles
0
P2.1.16
Motor Rs
0
P2.1.17
Motor Xs
0
P7.3.1.1
Pulse/revolution
(Number of encoder pulses)
2048
is going up
Make sure the number of
poles calculated
matches
the number for the motor
If motor rating is
unknown, leave at 0
If motor rating is
unknown, leave at 0
Number of pulses /
revolution of installed
encoder
5) If the encoder is an EnDat type, follow the procedure illustrated in paragraph 15.8 A) of the full MANUAL
step by step.
6) If the encoder is an incremental type, follow the procedure illustrated in paragraph 15.8 B) of the full
MANUAL step by step.
7) If it does not work perfectly, see the full MANUAL.
8) For other accessory functions such as POWER LIMIT, ONE FLOOR TRAVEL ONLY, DIRECT FLOOR
ARRIVAL etc. see the full manual.
TAKEDO - 3VF NXP USER MANUAL Release P06 dated 20-07-2010
7