Download S3Analyzer - Wurtec, Inc.

USING THE S3A
2. Connecting 1 S3Analyzer and S3Communicator(s)
FIGURE 2
Ring Tip/
TELCO
EXT
Ring Tip/
TELCO
EXT
Ring Tip/
TELCO
Box Tip
Ring Tip/
TELCO
Outside
Telephone
Line
Wurtec Inc. recommends the following physical connections when sharing a line with an S3Analyzer
and one or more S3Communicators. Refer to Figure 2.
Note: The S3A can lineshare with building powered version of the S3Communicator only.
Note: This scenario will not work when connecting to S3A #1 with a serial cable.
Note: Refer to circuit board diagram for S3Analyzer on page 47. For circuit board diagram of
S3Communicator, refer to the instruction manual that came with the emergency phone.
Note: The new S3Communicator will be available in early 2007!
ACCESSING INSTALLED S3A UNITS
Once a previously installed S3A unit is accessed either directly or remotely, the configuration used
will automatically be loaded into the software on your computer. See Figure 1A.
Next, click Action→Check and Reset Notification Log. This downloads any notifications that have
been stored in the unit and resets (synchronizes) the clock of the unit to the computer that is connected to it. See Figure 1B.
FIGURE 1A
46
FIGURE 1B