Download S3Analyzer - Wurtec, Inc.

S3A UNIT CONFIGURATION
Now connect the remote S3A unit to a computer and begin!
STEP 1
CONNECT CABLES
Connect the S3A to the PC with the supplied Serial Cable. Next connect the power cord into the S3A
and plug into a 110VAC source. See Figures 1A and B.
FIGURE 1A
FIGURE 1B
When power is supplied to the S3A, it will immediately try to call into the Host PC through the modem.
You should see the message in Figure 1C.
FIGURE 1C
NOTE: Make sure power is being supplied to the S3A by looking at the power light. It should be lit
bright red. If the Serial Cable is connected but not the Power Cable, the light may be dimly lit.
5