Download DC Analog Output Modules

Transcript
Chapter 4: Programming
DC Analog Output Modules
4.4: Setting the Channels
In this section, you are setting the channels to be either unidirectional or bi-directional.
As shown below, the number of packs will vary according to the number of channels you have in your
module.
SEGMENT UP
= Unidirectional
SEGMENT DOWN = Bi-directional
PACK NO. 1
PACK NO. 2
Electro Industries
1
2
Electro Industries
3
1
CHANNELS
0 1 23
Available for All Channel Models.
PACK NO. 3
2
Electro Industries
3
1
2
3
CHANNELS
4 5 67
CHANNELS
8 9
Available for 6- and 10-Channel
Models.
Available for the 10-Channel
Model.
STEP 5:
a. Press B2 to continue.
NOTE: Remember - SEGMENT UP = Unidirectional; SEGMENT DOWN = Bi-directional
Electro Industries
1
2
Electro Industries
3
NOTE: For a 2-Channel Module, you will set
ONLY the first 2 switch segments.
For 4-, 6- or 10-Channel Modules you will
set ALL of these switch segments.
STEP 6:
a. Press B3 to begin data entry sequence.
1
2
3
STEP 7:
a. Press B2 to toggle segments UP or DOWN for
desired setting.
b. Press B1 to Cancel.
b. Press B3 to store.
See Chapter 6 to Exit.
Electro Industries / GaugeTech DOC#: E104-7-03-07
21