Download DC Analog Output Modules
Transcript
Chapter 4: Programming DC Analog Output Modules 4.4: Setting the Channels In this section, you are setting the channels to be either unidirectional or bi-directional. As shown below, the number of packs will vary according to the number of channels you have in your module. SEGMENT UP = Unidirectional SEGMENT DOWN = Bi-directional PACK NO. 1 PACK NO. 2 Electro Industries 1 2 Electro Industries 3 1 CHANNELS 0 1 23 Available for All Channel Models. PACK NO. 3 2 Electro Industries 3 1 2 3 CHANNELS 4 5 67 CHANNELS 8 9 Available for 6- and 10-Channel Models. Available for the 10-Channel Model. STEP 5: a. Press B2 to continue. NOTE: Remember - SEGMENT UP = Unidirectional; SEGMENT DOWN = Bi-directional Electro Industries 1 2 Electro Industries 3 NOTE: For a 2-Channel Module, you will set ONLY the first 2 switch segments. For 4-, 6- or 10-Channel Modules you will set ALL of these switch segments. STEP 6: a. Press B3 to begin data entry sequence. 1 2 3 STEP 7: a. Press B2 to toggle segments UP or DOWN for desired setting. b. Press B1 to Cancel. b. Press B3 to store. See Chapter 6 to Exit. Electro Industries / GaugeTech DOC#: E104-7-03-07 21