Download iGp12-372F Signal Processor

Transcript
5.6 Display Panels
Figure 23: General-purpose I/O panel: bit-by-bit driver
mixer offset or, alternatively, to introduce an offset. Such an offset is typically
used when the beam loading transient is highly asymmetric to avoid reaching
ADC saturation prematurely. SATURATION LIMIT parameter defines the
maximum deviation from the phase setpoint that can be introduced by the
phase servo. This limit must be set below π/2 to make sure the phase servo
does not transition from one zero crossing to another.
Readouts on the bottom provide information on the ADC input offset
and the phase servo output. The bar indicator and the readout on the left
show the output of a Cascaded Integrator Comb (CIC) decimator which
averages 500 ms worth of ADC input samples (0.9 Hz −3 dB bandwidth).
The indicator on the right shows the phase servo correction applied to the
53 of 85