Download USER MANUAL

Appendix B
AT commands
B
In this appendix
This appendix contains a list of AT Commands for the EXPLORER 500.
Starting up an AT command session
Set up your computer to use either the USB or Bluetooth interface. For further information, see
Using the USB interface on page 68 or Using a computer with Bluetooth on page 71.
Connect your computer to the USB or Bluetooth interface of the EXPLORER 500 and launch your
terminal program.
The following section contains a list of commands that can be used with the EXPLORER 500. For
further information on the AT commands, refer to the following standards:
•
ITU V.250 Serial asynchronous automatic dialing and control
•
3GPP TS 27.005 ver. 4.2.0, Use of Data Terminal Equipment - Data Circuit terminating
Equipment (DTE-DCE) interface for Short Message Service (SMS) and Cell Broadcast Service
(CBS)
•
3GPP TS 27.007 ver. 4.6.0, AT command set for User Equipment (UE)
3GGP standards are found on www.3gpp.org
ITU standards are found on www.itu.int
TT 98-122274-R
172