Download USER MANUAL

Chapter 5: Using the web interface
Pointing using web interface
Instead of using the display for observing the signal strength you can view and accept the signal
strength in the web interface.
Do as follows:
1.
From the PROPERTIES section of the Dashboard, click the link Go to pointing mode. The
Pointing window opens, and the EXPLORER 500 enters pointing mode.
Note
At this point the EXPLORER 500 may make a sound. This sound is used for pointing
the antenna. The frequency of the sound increases with the signal strength.
To toggle the pointing sound on/off, press  or on the keypad of the
EXPLORER 500.
2. Point the antenna as described in Pointing the antenna on page 22, while observing the signal
strength in the web interface.
3.
When you have obtained the highest signal strength you can get, click Accept.
WARNING! After accepting the signal strength, keep the minimum safety
distance of 0.6 m to the antenna. The antenna may radiate microwave power as
soon as the signal strength is accepted.
The web interface now returns to the Dashboard, and the EXPLORER 500 tries to establish a
connection and register on the BGAN network.
TT 98-122274-R
Using the Dashboard
83