Download automated iris recognition system using cmos camera with proximity

Transcript
Figure 3.8: Proximity Sensor
Proximity Sensor
The proximity sensor used is an infrared proximity-collision sensor. It is
produced and manufactured by E-Gizmo Electronics and Robotics Shop. It has
two wires for input and one for output. The input wires which are colored red
and green are for the 5V supply and the ground connection, respectively. For its
power, it uses the Gizduino microcontroller board for its 5V source since this
microcontroller could deliver such a voltage output. It uses a TFDU6103 IrDa
transceiver (see datasheets for info). There are two of it in the sensor; one
serves as the receiver and the other as the transmitter. A blockade within 10cm
range will have it output a low signal. This sensor is used to send signal to the
microcontroller for the program to allow the camera to take a picture whenever
the sensor would detect that the person‘s iris to be captured is within the correct
distance. Furthermore, the sensor is composed of capacitors, resistors, LM555
IC, and LM567 IC.
31