Download UCM6510 User Manual

SYSTEM SETTINGS
This section explains configurations for system-wide parameters on the UCM6510. Those parameters
include Network Settings, Firewall, Change Password, LDAP server, HTTP server, Email settings, Time
Settings and NTP Server settings.
NETWORK SETTINGS
After successfully connecting the UCM6510 to the network for the first time, users could log in the web
GUI and go to Settings->Network Settings to configure the network parameters for the device. Select
each tab in web GUI->Settings->Network Settings page to configure LAN/WAN settings, 802.1X and
Port Forwarding.
Note:
To connect the UCM6510 to network, T1/E1/J1 data trunk can also be used, instead of using the
WAN/LAN port. Please see section [DATA TRUNK] to use UCM6510 data trunk to connect the device to
Internet.
BASIC SETTINGS
Please refer to the following tables for basic network configuration parameters on the UCM6510.
Table 5: UCM6510 Network Settings->Basic Settings
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510.
The default setting is "Route".

Method
Route
WAN port interface will be used for uplink connection. LAN port interface will
be used to serve as router.

Switch
WAN port interface will be used for uplink connection. LAN port interface will
Firmware Version 1.0.0.25
UCM6510 IP PBX User Manual
Page 31 of 233