Download Instruction Manual

8.1.2
Three-phase 400 V series
*1 Fuji 4-pole standard motors
*2 The rated capacity is for 440 V output voltage.
*3 Output voltages cannot exceed the power supply voltage.
*4 Interphase voltage unbalance (%) = Max.voltag e (V) - Min.voltag e (V) × 67 (Refer to IEC 61800 - 3 (5.2.3))
3 - phase average voltage (V)
If this value is 2 to 3 %, use an AC reactor (ACR).
*5 Tested under the standard load condition (85% load for applicable motor rating).
*6 Calculated under Fuji-specified conditions.
*7 Indicates the value when using a DC reactor (option).
*8 Average braking torque obtained with the AVR control off (F 05 =0). (Varies according to the efficiency
of the motor.)
*9 Average braking torque obtained by use of an external braking resistor (standard type available as
option).
*10 To make FRENIC-Mini compliant with category TYPE1 of the UL Standard (or NEMA1), an optional
NEMA1 kit is required. Note that the TYPE1-compliant FRENIC-Mini should be used in the ambient
temperature range from -10 to +40°C.
Note: A box (†) in the above table replaces A, C, E, or J depending on the shipping destination. Note that
the FRN4.0C1S-4 can be followed by E only.
8-2