Download Version 1.0 (PDF 605 kb)

Transcript
13.7.5 Sample Analysis
a) Analyze the method blank, samples solutions and spiked samples solution. Every sample should
be determined twice and the relative standard deviation should be no more than 10 % and the
recovery of spiked samples should be between 90 % and 110 %.
b) If the sample solution concentration does not fall within the range of the calibration standards,
prepare a serial sample dilution or additional standards to bracket the sample concentration.
CV-AAS
100 µl of the sample solution is given to 10 ml 1.5 % HNO3 and the measurement is done.
13.7.6 Calculation of Analytical Results
Data shall be analyzed using the following equation. Results shall be reported in mg/kg (i.e. µg/g).
ICP-AES
Instrument response (µg/ml) × Sample solution volume (ml)×Dilution factor
Result =
Sample mass (g)
AFS and ICP-MS
Instrument response (ng/ml) × Sample solution volume (ml)×Dilution factor
Result =
1000 ×Sample mass (g)
Note: Any serial dilution of sample must be included in the calculation.
CV AAS
V⋅X
= concentration of metal in µg ⋅ g −1
A ⋅W
where
V = total volume of the digestion solution in mL (250 mL for wet digestion, 25 mL for microwave digestion)
X = determined weight of metal in sample aliquot in µg
A = sample aliquot in mL (0.1 mL)
W = sample weight in g (1 g for wet digestion, 0.1 g for microwave digestion)
13.7.7 Test Report
The report should involve the following information:
a) The type and identification of the products tested
b) A reference to this standard, the used method (including digestion method and test instrument)
c) The results of the test expressed as milligrams / kilogram (“mg/kg”) in products tested
d) The detection limit or reporting limit
e) Any deviation, by agreement or otherwise, from the test procedure specified here
f) Date of the test and name of the operator
g) The detection limit
13.7.8 Quality Control
N.A.
Version 1.0
12/6/2004
50 of 79