Download Excellence 50XT

INSTAL L ATIO N MA N U A L
Error messages
English
Error code
Problem
F08
(follow-up)
Possible cause
Remedy
Ionization pin
defective (measure
ionization current when 0)
Replace the ionization
pin
F12
ESYS is not released
ESYS is in hard-lock
Wait half hour until ESYS
resets itself.
F13
Flame loss when only the
main burner is on
Gas has fallen away
Check gas supply
Gas control defective
(see "A" in app. 3, fig. 38)
Replace the gas control
Suffocation due to poor
flue gas channel
Check the concentric system
Check the setting of the
appliance
F14
Flame loss if both burners
are on.
Suffocation when using
PowerVent
Check the pressure setting
of the PowerVent system
24 hour check control
Reset with remote control
(consult Powervent manual)
Gas has fallen away
Check gas supply
Gas control defective (see "A"
in appendix 3, fig. 38)
Replace the gas control
Suffocation due to poor flue
gas channel
Check the concentric system
Check the setting of the
appliance
Suffocation when using
PowerVent
Check the pressure setting of
the PowerVent system
Burner device came loose
from burner device
Attach the burner device
Burner device incorrectly
mounted
Mount the burner device
correctly
Pins on the connector on the
gas control are bent
Bend them straight
High limit error
High limit bridge defective
Check High limit bridge ESYS
F16
Hardware Error ESYS
ESYS defective (burner
device)
Replace ESYS (burner device)
F17
Disable contact is closed
Window is open.
(if this contact is present)
Close window
A bridge has been made
across the Disable contact.
Remove bridge on ESYS
(burner device)
F15
UK
No burner device (see "C" in
appendix 3, fig. 38)