Download Manual

Commands of the menu Edit
Factor & Offset
69
manufacturer. Normally it is the same for all axes within the
project.
Factor and offset help to display physical values by applying
multiplication and addition before displaying them. The value is
calculated by the following formula: DisplayedValue =
Value*Factor + Offset
For 3d-Map-Windows:
The fourth sheet contains information about the three-dimensional view.
Rotation
This determines the rotation of the view around the vertical axis.
Perspective
The value shows the influence of the perspective on the view.
Z-Scaling
The Z-Scaling determines how much the map is stretched or
compacted vertically for the view.
Z-Offset
The Z-Offset is a vertical offset which can be used to make
negative values displayable.
Show axis
If this checkbox is checked, an axis description will be displayed.
description
Shortcuts
Symbol bar:
Keyboard: Alt+Enter
5.6
The Command Apply Checksum (Menu Edit)
Use this command to let WinOLS recalculate a single checksum block. If the
automatic checksum calculation is enabled, you won’t need this command.
This command is only available if the cursor is within a checksum block and the
corresponding plugin is installed and registered.
Shortcuts
Symbol bar:
Keyboard: Alt+F2
(C) 2007 EVC electronic