Download FlexDC Motion Controller User Manual

FlexDC User Manual
Quick Start
2 Quick Start
The purpose of this chapter is to provide the user with easy step-by-step instructions for first
time operation of the FlexDC using RS232 communication.
WARNING !
Before powering the FlexDC, motors cable connectors must be connected to the
motor outlets of the controller, as hazardous voltages may appear on controller's
motor outlets. Only a person who has read the instructions in sections 2.1 and 2.2
may handle the FlexDC.
2.1 Safety Precautions
1. Do not open the FlexDC enclosure.
2. Verify that the motor is properly assembled on the stage and preloaded,
before operating the stage.
3. Verify that the motor and the encoder connectors match the FlexDC rear
panel connections (refer to sections 4.3.11 and 4.3.12).
4. Do not cover the vents on the top panel of the FlexDC.
5. Verify that the stage's movement is not interrupted by nearby impediments.
WARNING !
Connect / disconnect the motor cable from / to FlexDC, only when the main power
cord is disconnected from the wall outlet.
D/N: FLDC458000-01 REV: A
Nanomotion Ltd.
15