Download User Manual

Transcript
Chapter 8: M ain Toolbar Features
Card 12
REINF: free-stream Reynolds number
REFLEN: reference length used to calculate REINF
IDRAG: when the value is 0, no viscous drag is calculated. When the value is 1, a
viscous drag calculation is performed.
 Note: if IDRAG is 1 and a stab/control run is being run – the drag used in
the S&C calculations will be the TOTAL drag (Cdi + Cdf)
NUMREN: number of Reynolds numbers in Mach/Re/Cl-Cd table
NUMMCH: number of Mach numbers in Mach/Re/Cl-Cd table
Slice Tab
Auto Slice
Auto Find: places a key slice wherever a slope discontinuity in the shape occurs.
Auto Eliminate: removes any unnecessary key slices.
Auto Merge: combines any key slices placed closely together.
Auto Slice: places interpolated slices throughout the structure
Auto All: will simultaneously Auto Find, Auto Eliminate, Auto Merge and Auto Slice.
Flat Plate: approximates a 2D geometry from the figure.
Swap XY: interchanges X and Y values.
Reset: will restore the original conditions.
VSP User Manual
69
Version 1.7.92