Download Building Access Controller 32

17
9
Web Browser (Editing)
9.1
System
In the Edit > System menu, fill in the following fields with the appropriate information to begin
configuring your Building Access Controller 32.
The Edit > System menu
Field
Description
Name
Name of this device, used for your reference.
Location
Location of this Building Access Controller 32, used for your reference.
Contact
Contact phone number for the person responsible for this Building Access Controller 32.
Serial Number
Assigned at the DPS Telecom factory for unique unit identification.
DCP Port
Enter the DCP Port for this Building Access Controller 32, then select between UDP/TCP.
In-Facility
Broadcast
When checked, the "In-Facility Broadcast" function is active. This is an alternate mode of
operation and is not commonly used. (see later section for description)
In-Facility UDP
Port
The UDP port used to broadcast "In-Facility" notices to other BACTL 32 units. This port is
also used to listen for incoming broadcasts. Default port is 6000.
The number of broadcasts (from 1 to 3) that will be executed for each "In-Facility" notice.
In-Facility Send
Since broadcasts receive no response, sending more than one broadcast increases
Count
reliability. Broadcast retries occur within a few seconds of each other. Default send value is
1.
Normally Open
Door Alarms
When checked, all door alarms attached to this Building Access Controller 32 will reverse
their polarity from "normally closed" to "normally open".
Door Unlock
Duration
The number of seconds (from 1 to 30) that a door will remain unlocked after a valid
electronic entry (manual card swipe or keypad, or remote unlock from T/Mon).